STEP STEP INSTALLING GLASS FRAMELESS

-->

STEP STEP INSTALLING GLASS FRAMELESS

1. prepare the hole areas of glass will be placed.

2. Create overdraft at the top of the wall and bottom of the glass as deep and knowledgeable 1.5 cm

-->
-->

-->

3-4. Place the aluminum frame shaped "U" with a size of 1 cm on the inleting

5-6. Give the sealant along the top and bottom overdraft and the aluminum casing. Then, enter the glass with a sloping position.

-->

-->

7. Close the slit in the form Ujung The Right and the left glass with Sealant.
8. Clean the glass with Wet Koran. Glass were ready with Kuate installed.

YOU NEED TO KNOW

Overdraft  made only on the field side of the window hole long course, not the short side or the width. If the glass is shaped vertical dead, overdraft made only on the wall of the left and right. If the window-shaped hole horizontal overdraft made on the top and bottom on both sides because that is the length of which is the specialty glass.

To open or replace the glass. You can strip sealant from overdraft on the length of the window. Position with the glass removed italics. For the glass back, adjust the steps recommended to install or place the new glass.

Note the size aluminium frame is used. Frame size is only 1 cm thick with jaca to below 5 mm. Glass with 8 mm thick to the top, you should use a frame size ranging from 2 cm, so that this process of entering and removing the glass easier and glass can touched strong.